It is built in to the rear window along with the rear defroster.
The map sensor is located on the intake manifold on a 1996 Olds Achieva 2.4 liter. It is in the center of the intake manifold.
i have a 96 olds achieva and my high beam light was flashing, i checked the headlights and one of my low beam headlights was out. once replaced the flashing stopped.
replacing achieva serpentine on a 96i have a 96 and you have to completely remove the motor mount and all of the bolts holding it on the engine to replace the belt,also carefully jack up the engine since it will fall on the ground if you take off the mount
The 1996 Oldsmobile Achieva typically has three motor mounts: two side mounts and one rear mount. These mounts help secure the engine and minimize vibrations. It's important to check their condition, as worn mounts can lead to excessive movement and noise.
Under the hood on the drivers side behind the battery on the fender under the brace.
*96-98 Olds Achivea *96-01 Pontiac Grand Am *99-01 Olds Alero *96-01 Pontiac Sunfire *96-01 Chevy Malibu *96-? Buick Skylark *96-98 Olds Cutlass
On a 96 xjs, It is in the trunk on the right side behind the cover the hides the electric antenna; likely to be the same for a 96
On my 95 it is above the starter. it might be the same.
No, they dont!
Most cars are anywhere between 750-800 rpms
It's concealed in the roof
To bleed the cooling system on a 1996 Oldsmobile Achieva, first ensure the engine is cool. Remove the radiator cap and start the engine, allowing it to reach operating temperature. As the thermostat opens, air bubbles will escape; keep an eye on the coolant level and add more if necessary. Once the bubbles cease and the coolant is at the proper level, replace the radiator cap securely.