Locate the thermostat housing. It is the spot behind the fan blade where two hoses connect. Unhook the large radiator hose. Unbolt the bolts holding the hoses in place. Coolant may leak out, so you may want to place a bucket under your Jeep and a bit behind the radiator to catch it. Swing up the manifold and scrape off the old gasket. Pull out the old thermostat. Make sure the thermostat casing and all the surrounding hardware is clean. Spread some RTV on the gasket. Place the new thermostat in the housing, ensuring it is lined up properly. Put the manifold back over it, and bolt it back down. Top off the radiator with 50/50 mix.
thermostat
No
Around 4000 lbs
You can buy 2007 Jeep Commanders from used Jeep dealers on your local area. To find a list of new and used Jeep dealers in your area check your local yellow pages.
Changing a thermostat on a 1995 Jeep Cherokee is very easy to do. The thermostat has two bolts holding it in place. Take the bolts off and remove the thermostat from the casing and replace with a new one.
Remove thermostat housing, remove old thermostat, clean surfaces, install new gasket and thermostat.
Depends on the engine and whether it has a towing package
Same way you do for every other car.
To change a headlight on a 2007 Jeep Commander, first, open the hood and locate the back of the headlight assembly. Disconnect the power connector by pressing the tab and pulling it straight out. Remove the headlight bulb by twisting it counterclockwise and then replace it with a new bulb, ensuring it’s secure. Finally, reconnect the power connector and test the headlight before closing the hood.
Sell it to a sucker!
Jeep Commander was created in 2006.
Answering "http://wiki.answers.com/Q/How_do_you_fill_transmission_fluid_on_a_2007_jeep_commander"