You have to drain/remove the "transmission" oil pan to get access to the filter.
how do you change rear wheel bearing in 1994 Plymouth acclaim
you have to remove the dash
Buy a replacement car!
what do I need to change the 1997 Plymouth voyager transmission oil
The slave cylinder is INSIDE the transmission bellhousing , it slides over the transmission input shaft , and then is bolted to the transmission. To change the slave cylinder the transmission has to be removed , but the slave cylinder line can be blead from the bleeder outside of the transmission bellhousing
The slave cylinder is on the input shaft of the transmission at the throw out bearing. The transmission will have to be removed to change it.
Yes , the slave cylinder for your hydraulic clutch is inside the manual transmission bell housing. It slides over the input shaft to the transmission and is bolted in place inside the transmission . To CHANGE the slave cylinder the transmission has to be removed , but the lines to the slave cylinder CAN BE BLEAD from a fitting that extends outside of the transmission bellhousing
slave cylinder locationin the Mercury mystique the slave cylinder is located in the transmission. it is connected to the release bearing. the onbly way to change the slave cylinder in this perticular car is to pull the transmission. stupid desing but its a ford so this kind of briliant thinking is expected..lol
Remove transmission oil pan for access to filter. Replace pan gasket, fluid and filter
About 5 for a filter change. 9 for dry fill.
1 litre
Yes, you must pull both axles to change any transmission, Mazda or not.