answersLogoWhite

0

slave cylinder locationin the Mercury Mystique the slave cylinder is located in the transmission. it is connected to the release bearing. the onbly way to change the slave cylinder in this perticular car is to pull the transmission. stupid desing but its a Ford so this kind of briliant thinking is expected..lol
User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you check the slave cylinder fluid level on a 2000 Mercury Mystique?

the brake and clutch are both contained in the same reservoir and use the same fluid, look at the side of the brake master cylinder reservoir there is a fill line on the side of the clear reservoir


How do you change a slave cylinder on a 1991 Mazda MX-6?

How do you change a slave cylinder on a 1995 Mazda B2300 2wd?


How do you change internal slave cylinder to an external slave cylinder on a 1993 wrangler?

no none of the answers were my question


Where is slave cylinder on 1997 Isuzu hombre?

The slave cylinder is on the input shaft of the transmission at the throw out bearing. The transmission will have to be removed to change it.


Do you have to pull motor to change the clutch slave cylinder?

Yes


How do you change a slave cylinder on a Saab 9-5 2002?

To change the slave cylinder on a 2002 Saab 9-5, first, safely lift the vehicle and remove the transmission to access the slave cylinder. Disconnect the hydraulic line and remove the retaining bolts for the slave cylinder. Install the new slave cylinder, reconnect the hydraulic line, and bleed the clutch system to remove any air. Finally, reassemble the transmission and lower the vehicle.


Is the slave cylinder on the inside or outside of the transmission of a Ford Ranger 2002?

The slave cylinder is INSIDE the transmission bellhousing , it slides over the transmission input shaft , and then is bolted to the transmission. To change the slave cylinder the transmission has to be removed , but the slave cylinder line can be blead from the bleeder outside of the transmission bellhousing


How do you change the clutch slave cylinder in a 93 Ranger?

very carefully


How do you change the slave cylinder out of a 1994 Ford F250 4x4?

i think you have to change the master and the slave cly as i think ther'e one unit


How do I replace clutch cable mercury capri 93?

There is no clutch cable in 93 Mercury Capri. Its operated by hydraulics. There is a clutch slave cylinder and master cylinder. the seal in it probably worn out. Not very hard to work with.


Where is the slave cylinder?

It depends on the slave cylinder that you are asking about. The slave cylinder for a hydralic clutch would be neer the bell housing to disengage the clutch. The slave cylinder for drum brakes would be inside the drum between the two shoes, and pressure applied into this cylinder would engage the brakes.AnswerThe clutch slave is inside the bell housing on most of these. You have to pull the transmission etc to change it out. ANSWERSTRANSMISSION HOUSING OUTSIDE FLUID PIPE


How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?

You will need to remove the transmission to replace the clutch slave.