You need to check for 12v at washer pump connection when washer turned on. If 12v present at harness connector but pump not working, replace pump. If pump is working, but no fluid coming out at wipers, you will need to remove front hose and blow out any debris clogging hose.
The windshield washer pump on a Dodge Caravan is easily replaceable because it is accessible from the hood. The old pump should be removed and the new one connected in its place.
It is on the bottom of the washer bottle.
where is the rear windshield washer fluid kept ? where is the rear windshield washer fluid kept ?
The windshield washer pump is located on the firewall in the engine compartment. Remove the windshield washer pump hose. Remove the wiring harness. Remove the windshield washer pump retaining screws. Reverse the process to install the new windshield washer pump.
No fluid, blown fuse, bad pump, plugged hose,
The windshield washer pump is attached to the washer fluid reservoir. You will find 2 pumps attached to the reservoir. The other pump feeds the rear window. The reservoir can be unbolted and removed from the engine compartment.
No.
To add washer fluid to the rear window washer on a 2010 Dodge Caravan, open the hood and locate the washer fluid reservoir, which is typically near the back of the engine compartment. The reservoir cap is usually marked with a windshield/water symbol. Remove the cap and pour the washer fluid into the reservoir until it reaches the recommended level, then replace the cap securely.
The front windshield wiper size on a Dodge Caravan is 26 inches for both driver and passenger. The rear windshield blad is 16 inches.
take off front bumper and you will see the screws holding it in place
The washer pump is located at the bottom of the winshield washer resevoir. There are 2 pumps...one for the front and one on the back. All you need to do is remove the wire assembly from the pump and it pulls out of the resevoir. It will take some muscle to get it out because of the press fit washer. Be careful of washer fluid coming out once you remove the pump. Good Luck
To change the windshield washer fluid pump on a 2007 Dodge Dakota, first disconnect the negative battery terminal for safety. Remove the windshield washer reservoir by unclipping it and disconnecting the hoses. Once the reservoir is out, locate the pump at the bottom, detach the electrical connector, and twist the pump counterclockwise to remove it. Replace it with the new pump, reassemble the reservoir, and reconnect the battery.