The windshield washer pump on a Dodge Caravan is easily replaceable because it is accessible from the hood. The old pump should be removed and the new one connected in its place.
The windshield washer pump is located on the firewall in the engine compartment. Remove the windshield washer pump hose. Remove the wiring harness. Remove the windshield washer pump retaining screws. Reverse the process to install the new windshield washer pump.
It is on the bottom of the washer bottle.
The windshield washer pump is attached to the washer fluid reservoir. You will find 2 pumps attached to the reservoir. The other pump feeds the rear window. The reservoir can be unbolted and removed from the engine compartment.
where is the rear windshield washer fluid kept ? where is the rear windshield washer fluid kept ?
To add washer fluid to the rear window washer on a 2010 Dodge Caravan, open the hood and locate the washer fluid reservoir, which is typically near the back of the engine compartment. The reservoir cap is usually marked with a windshield/water symbol. Remove the cap and pour the washer fluid into the reservoir until it reaches the recommended level, then replace the cap securely.
Expect to pay about $350.
No fluid, blown fuse, bad pump, plugged hose,
They are all done about the same. go here http://www.wikihow.com/Replace-Your-Automobile-Windshield
To add washer fluid to the rear window washer of a 2013 Dodge Caravan, locate the washer fluid reservoir under the hood. It is typically a translucent tank labeled with a windshield/water symbol. Open the cap and pour in the washer fluid until it reaches the desired level. Be sure to close the cap securely after filling.
No.
A windshield washer pump on a 1998 Dodge Avenger ES is screwed onto the bottom of the washer fluid canister that holds the washer fluid.
You need to check for 12v at washer pump connection when washer turned on. If 12v present at harness connector but pump not working, replace pump. If pump is working, but no fluid coming out at wipers, you will need to remove front hose and blow out any debris clogging hose.