0
It is simple. 1. Remove 4 screws holding the plastic cover (screws are at the bottom half of cover behind steering wheel) 2. Remove the bottom half of cover 3. Remove two retaining screws holding the switch 4. remove two bunched up wires plugs (be careful, remove by lifting/pressing the locking retaining plastic clips) 5. Insert plugs into new switch, put it in place and fasten two screws 6. Insert the cover and fasten 3 screws removed earlier Note: you may have to play a little to tilt steering wheel up/down to get better access to screws of the switch
What else can I help you with?
Where is the location of Turn signal relay switch for Mercury Villager 1995?
The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
How do you change the rear wiper switch in a 1997 Mercury Villager Van?
The switch just pops out of the dashboard.
How do you change the driver side window switch on a 1999 mercury villager?
It's held on by one screw in the hand hold.
Why would the windshield wipers only work when the right turn signal is on on a Mercury Villager?
You probably have shorted wires inside the combo switch. The assembly will need to be replaced.
Where is the neutrl safety switch located on a 1995 mercury villager gs?
It's part of the range switch on the transmission.
Where is the mercury villager hazard light switch?
Usually on the dash to the right of the steering wheel.
Where is the soleniod switch on 1997 Mercury villager?
If you mean the starter solenoid, it's on the starter.
Where is the brake light switch located on a 1994 mercury villager?
On the brake pedal assembly.
Where is the cruise control brake pedal switch on a 2002 Mercury villager?
On the brake pedal.
Where is the reset button on 2000 mercury villager?
If you mean the reset button on top of the FUEL PUMP SHUT OFF SWITCH the switch is located in the drivers footwell , behind the kick panel , by your left foot ( there is an access hole ) on a 2000 Mercury Villager
Where is the neutral safety switch on a 1994 Mercury Villager located?
It might be the transmission range selector
Where is the inertia fuel switch in a 1993 Mercury Villager?
behind the drivers side kick panel
