answersLogoWhite

0

1. If working on the left side , remove the air cleaner , heat duct and crankcase ventilating breather.

2. If working on the right side remove pcv valve and elbow from cover. Remove Alternator wiring harness from clips.

3. Remove spark plug cables clips from studs and move them out of the way.

4. Remove seven bolts and two screw studs holding cover to head and remove cover.

If removal is difficult , use a hammer and a block of wood to loosen. Do not pry on valve cover!!!

Use Rtv when installing the new gasket. Installation is the reverse of removal. Tighten all bolts to 30 inch pounds. Reattach all spark plug wires and everything else that was disconnected. check for leaks.

User Avatar

Wiki User

15y ago

What else can I help you with?