Generally speaking you can clear trouble codes by either removing the fuse to the engine control module or by disconnecting the battery. In either case the ignition should be off.
Hope that helps.
There isn't a trans filter on the Firefly manual trans.
take off the negative cable for 10 sec. or so, that should clear all the codes and reset the computer.
If your looking for replacements try this link. http://www.fbodymotorsports.com/93_02_clear_lights
Most FWD cars can still have the engine removed from the top....just as the old RWD cars. If it's an automatic trans unbolt the trans and the torque converter from the engine. Support the trans and leave it in the car. Most of the time it's easier to pull a 5 speed trans with the engine.....but you'll need to be able to tilt the engine quite a bit to clear everything as you pull it.
First check coolant levels, if they are correct. Try disconnecting the battery ground connection for 5 minutes to clear the prom, then reconnect and start the car. If the light is still on, then the sensor is bad, and must be replaced.
Should be able to just unbolt the valve cover, remove the old gasket clear the surfaces with a rag and reinstall. Might have to disconnect the throttle/trans kickdown cable from the throttle body for room.
Buy a Haynes Repair Manual or a Chilton Repair Manual for a 2000 Firebird. Both have clear schematics for all electrical systems.
After repairing the cause of the code, you can clear it with a scan tool.
The cast of Solo Trans - 1984 includes: Newell Alexander as Dan Clear Inez Drummond as Baby Rosemarie Lovell as Crystal Clear Connie Simmons as Connie Sue Neil Young as himself Pegi Young as Honey
To troubleshoot a clog in your sink pipes, you can try using a plunger to dislodge the blockage, using a plumber's snake to remove the clog, or using a chemical drain cleaner. If these methods don't work, you may need to call a professional plumber to help clear the clog.
I added a link for you to check out. According to this site it will fit. I do know that the thermostat housing is different and that you will have to run a point type distributor as the HEI won't clear the carb. A Mallory Uni-lite might clear. Not sure.
To troubleshoot a clogged sink water line, you can try using a plunger to clear the blockage, using a plumbing snake to remove debris, or using a chemical drain cleaner. If these methods don't work, you may need to call a professional plumber to help resolve the issue.