You need to locate the green/orange wire on the drivers side kick panel. Upon retreval splice into it with same gage wire and ground this wire end to the chassis. This should kill the alarm but not the cars ability to run. If car still wont run check the crank sensor.
i need to disable jeep factory alarm 1997 cherokee
The factory alarm can not be disabled, only repaired if malfunctioning.
pull the 15 amp fuse in the fuse box.
A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.
You will have to uninstall the alarm and rewire the vehicle. It is likely the ignition wires are run through the alarm.
on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps
Is it possible that the Jeep is a Laredo with an alarm. My jeep did the same thing after I installed a new starter. What I had to do was close the driver side door, lock it, and then unlock it to disable the alarm. Hope this helps.
To disable the alarm security on a 1994 Jeep Grand Cherokee, you can try disconnecting the battery for a few minutes to reset the system. Additionally, using the key in the driver's side door to unlock it can sometimes disarm the alarm. If the alarm persists, locate the alarm module, usually found under the dashboard, and disconnect it directly. Always consult the owner’s manual for specific instructions related to your model.
The coolant temperature sensor on a 2001 Jeep Cherokee is located in the intake manifold. It monitors the flow and temperature of coolant through the engine.
An AW4 transmission from a 1991 Jeep Cherokee will not fit into a 1988 Jeep Cherokee. The transmissions in the varying years do not appear to be compatible with one another.
You can not. The "alarm" is an integral part of at least three computers on the Jeep. The pcm (engine), bcm (body functions), and the skim (chip key system).
Get a big hammer and beat it.