To disable the Daytime Running Lights (DRL) on a 2002 Chevy Prizm, you can locate the DRL relay under the dashboard. Remove the relay or disconnect the wiring harness leading to it. Alternatively, you can fuse the DRL circuit by removing the appropriate fuse from the fuse box. Always consult your vehicle's manual for specific instructions and safety precautions.
I just changed oil on my sister-in-law's '02 Prizm. It took a 15mm.
It requires a scanner as the new computors keep history codes. Removing a battery cable will NOT do it.
the po420 could also be a misfire or vacuum leak
If you get it real cheap ;yes, it is worth the gamble. mine has 165000 i got it back in 02' what is there asking price
To replace the blower motor resistor on a 2002 Chevy Prizm, first disconnect the negative battery terminal to ensure safety. Remove the lower dashboard panel to access the resistor, which is typically located near the blower motor. Disconnect the wiring harness from the resistor, unscrew it from its mounting position, and replace it with the new resistor. Finally, reassemble the dashboard panel and reconnect the battery terminal.
Three answers: 1. Remove the bulbs 2. You can't disable them 3. Remove the bulbs, paint them black, and put them back (this might be a fire hazard) ---------------------------- Actually, if you removed the bulb sockets from the wiring harness and then added a properly-sized resistor to the circuit, you might just be able to fool the car.
Easiest way, pull the fuse from under the hood. It should be labeled. You'll probably lose traction control too, and ebrake/tc/abs lights may stay on all the time.
Well you could ...by pulling the wire off but DON'T, your 02 sensor is part of what the ECU uses to set fuel/air trim and your car will run like, um, badly
Answer Options. There a few features that are standard on the LSI that are options on the Base model (if I recall it is things like tach, power windows/locks, folding rear seat, things like that). I always thought the way to tell the difference between the two was the trim around the windows. LSI has black trim while the base is mostly body colored. Having said that I have 02 Base with the above features, no black trim and my Insurance says it's a LSI. Go figure.
To disable the 3G capabilities, go into the phone's network settings. There should be an option to set the phone into GSM instead of dual mode or 3G mode. Doing this will disable the 3G until the phone user changes the settings to turn it back on.
There actually was not 1 player because you have to capped as a unit or team. These are the players registered with the WRU as formal caps for the first cap issue BevanJim10Wales19/02/1881DarbishireGodfrey10Wales19/02/1881GirlingBarry10Wales19/02/1881LewisEdward10Wales19/02/1881MannBathurst10Wales19/02/1881PeakeEdward10Wales19/02/1881ReesAneurin10Wales19/02/1881SummersRichard10Wales19/02/1881WatkinsLeonard10Wales19/02/1881WilliamsRichard10Wales19/02/1881
I Make Hamburgers was created on 1995-02-02.