its behind passenger side rear wheel near boot
rear right hand side of engine next to turbo
Pass. side rear, behind shoulder strap of seatbelt
just been chating to a bloke around the corner he has a mark 1 mondeo and changed his bumper.Taking it of if fiddley 4 bolts at the bottom and screws at the side. You might have to drop your exhaust a bit to get at bolt
Passenger side rear of engine bay
Once a seatbelt starts sticking its gonzo and needs to be replaced.
The batteries in a Ford Mondeo key fob go in with the positive side facing up. This is the more flat side with the writing on it.
yes mate it will no modifications will be needed at all. the zetec -s body kit fits directly onto mk1 and mk2 mondeo's |The "Zetec S" bumper will fit the zetec engined models but will not fit the V6 as the exhaust exit for the V6 is on the right hand side. So in a nutshell Zetec S (RSAP) rear bumper will fit the 2.0, 1.8 & 1.6 models (exhaust on left) and the ST24 (RSAP) bumper will fit the V6 (exhaust on right) It also depends on model of car. Only the Saloon and Hatchback are interchangeable, the estate bumpers are completley different Hope it helps :-)
Your parking/ side light/headlights switch not only rotates but also pulls out towards you thus switching your rear fog lights on. simply push switch in the way.
mondeo 1.8 mk3 right side of battery and there are 4 cubes 1st left side and under 1
on a v6 mondeo st24 the spped sensor is on the right hand side of the gear box access is gained frm under the car on a v6 mondeo st24 the spped sensor is on the right hand side of the gear box access is gained frm under the car
the front impact sensors are between the lower radiator support and front bumber. If equipped with side impact sensors they would be located in the panel the front seatbelt straps pull out from. The rear sensors are located between the rear bumper and rear axle on the frame rail