0
To fit a trip computer and temperature sensor to a Ford Mondeo MK2, you'll need to ensure you have the correct components compatible with your vehicle model. Start by locating the trip computer unit, which usually fits in the dashboard, and connect the necessary wiring harness to the car's electrical system. For the temperature sensor, install it in the appropriate location, typically in the engine bay or near the radiator, and connect it to the trip computer. Finally, verify all connections and test the system to ensure it functions properly.
What else can I help you with?
Why does the trip computer beep when the outside temp reaches -5C degrees on my 2002 Passat trip computer?
To warn you that there might be ICE on the roads To warn you that there might be ICE on the roads
What is a VW MFA?
multi funktion adapter, its just a trip computer that shows mpg, oil temp etc etc
Should you use teflon tape on a water temp sensor?
Most likely not. If the sensor reads hot it will short to ground through its casing and trip the warning signal. The tape can prevent it from reaching ground.
What does the Turbine Input Sensor do?
The Turbine Input Sensor is used by the computer to determine transmission speed. There are several back-up sensors that the computer can use in the event the Turbine Sensor fails. A failed sensor will trip the Check Engine light, but the car will still run and you can still drive it.
How do you reset temperature setting from Celsius to Fahrenheit on a 1993 Lincoln mark 8?
on the trip computer it says miles/km if you press this and it converts to miles it will convert the temp from Celsius to Fahrenheit
You recently changed the speed sensor in your 1990 dodge b250 van the speedometer works the trip and odometer dont any ideas?
If a person recently changed the speed sensor in a 1990 Dodge B-250 Van and the trip meter and odometer do not work, there could be a fuse that needs to be replaced. The computer might also have to be reset to allow for the odometer and trip meter to work.
Grand prix fuse for the trip computer?
where is the fuse for the trip computer on a 2001 gran prix
How do you reset trip computer Mazda rx8?
To reset the trip computer in a Mazda RX-8, turn on the ignition without starting the engine. Locate the trip computer button on the dashboard or steering wheel; it may be labeled "Trip" or "Reset." Press and hold this button until the display resets to zero. Release the button, and the trip computer should now be reset.
Why is Knock Sensor Code 34 continuously being triggered on a 93 Altima computer when you can reset it and it runs fine for a couple of weeks then it will trigger again and everything has been checked?
You need to replace that sensor, but it's not an easy job. I recommend to take you car to a specialist.Yes, replace the sensor. The a bad knock sensor will not immediately trip CEL until the vehicle has run through several cycles - hence the delay between clearing the computer and the light coming back on.
Will bad O2 sensor trip the check engine light?
Yes.
Your trip computer on xjs 1985 5.3he has stopped working after being stood for 3 years?
There is a fuse in the back of the trip computer that needs to be replaced
How do you reset trip computer on 2004 Acura MDX without navigation system from kilometers to us?
Hold the trip button down for 5 seconds and kilometers will switch to miles along with Celsius to Fahrenheit on trip computer display.
