Buy a new one. very costly though. I'd also suggest putting epoxy aound the plastic pieces for more strength, $100 plus is a lot of money because a tiny platic cable guide breaks. just make sure the epoxy doesn't interfere with the movement of the cable
You will need a new regulator assembly.
Most likely the guide on the bottom of the regulator broke. take the door apart and check. most likely, you need a new window regulator.
A Dodge Durango window motor can be ordered from any auto parts store. The prices for the window motors will vary depending on the year of the Durango.
Were is the power window fuse and/or circuit breaker located in a 1999 dodge durango?
To fix a power window on a Dodge Durango that won't stay closed, first check the window switch for any signs of damage or wear. If the switch seems functional, inspect the window regulator and motor; a faulty regulator may need to be replaced. Additionally, ensure that the window track is clean and free of obstructions. If these components are in working order, consider reprogramming the window by holding the switch in the up position for a few seconds after the window is fully closed.
No.
on the 01, probably close enough to the same thing, remove the door panel, then you need the window about halfway down, there are two bolts that hold the window onto the regulator and two bolts on the bottom and two on the top of the regulator. it helps if someone can help hold the window, if not duct tape works pretty good.
The voltage regulator is located in the PCM if it is going out you have to replace the entire computer
07 Durango SLT 35% in rear
is located on top of the housing of the fuel pump.
Yes. The regulator is part of the pump module in the fuel tank.
To replace the driver's window in a Dodge Spirit, first, remove the door panel by unscrewing and prying off any clips holding it in place. Carefully detach the old window by removing the window regulator and any necessary bolts. Install the new window by aligning it with the window tracks, reattach the regulator, and then reassemble the door panel. Finally, test the window's operation before fully securing everything.