answersLogoWhite

0

First you need to check and see if there are any codes thrown by the PCM,if there are start your diagnossis there.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you fix blow by on 350 chev engine?

You must replace the piston rings. That means TIME FOR A REBUILD.


Oil leaks out and crack in motor can this be fix easy?

No. Get rid of the car or replace the engine!


Is there anyway to fix a Chevrolet 350 truck motor from water linking in the block?

Most l;ikely but you have to get it diagnosed. Could be a head gasket


How can you get rid of jello mold oil from engine?

Try Gunk High Mileage Motor Flush to clean engine and Bars 2 Part Engine Fix to restore engine performance.


Can you fix a blown motor?

It would be more cost effective to replace the blown engine with a re-manufactured one.


How do You Turn off check engine light on 2004 F-350 diesel?

with scan tool but you must fix the problem to keep it from comming on .


Where is the freezeplug located on a 350 motor?

There is 8 plugs total. There is two in the back of the engine where the fly-wheel bolts to the crank. You will have to pull the transmission or engine to fix those. There is 2 plugs on each side of the engine block just below the heads. Now one on each side of the engine is hidden behind the motor mounts, and one is behind the starter, then the other one you can see. Now there are two on the front of the engine just below the front of the heads. You will have to remove all the stuff that is bolted on the front of the engine to get to them. That makes 8. Tough job to do. GOOD LUCK NEUTZ.


How do you fix a motor mount on a Chevy Malibu?

you take the rear turbine out of the engine and clean it and then make it dirty again and put it back in


How do you fix a motor mount on a 1995 gmc?

The year, make, model and engine wasn't mentioned but in general you remove the motor mount anchor bolt(s), lift the engine a few inches and support it safely, unbolt motor mount(s) from engine, remove mount(s), replace mount(s) and finish in reverse order.


How do you fix a OBD on a Ford E-350?

no


How do you fix a rough idle in a 94 Ford Tempo 2.3l engine automatic in gear break applied?

Check for broken motor mounts.


How you fix a 96 Ford Tempo if the engine shakes when the car is in drive?

The car needs a tune-up, or the motor mount(s) are bad.

Trending Questions
How do you remove the axles from the transmission of a 1990 Dodge Colt Standard with 15-L engine for the purpose of replacing the transmission? How much force does it take to bend the rear bumper of a 1990 ford bronco? Reactivate air bags in 98 Cadillac DeVille? Where is the cigar lighter fuse on Oldsmobile alero? How do you remove the ignition lock barrel of a 1974 Nova without the key? What are the top 10 life insurance companies in America? Where is the air control valve located on 2000 cavalier? What other year truck parts are interchangeable with a 1971 Chevy C 20 pickup for clutch pedals? How do you remove woodgrain dash panel on 92 roadmaster? What is the spark plug gap for a 1969 318 engine? How expensive is to replace the thermostat of the 2001 aztek? How do you reset tire pressure monitoring system on 2007 Chevy Avalanche? 89 jeep wrangler transmission gets stuck in 1st gear? 91 gmc suburban gets fuel to tbi but won't spray through injectors? Where could you find a diagram for repairing ignition switch on 2000 Chevy Impala with 34 LT engine that remote was lost causing it to lockup? What is the spark plug gap for 1999 Mercury Villager? Does 2006 Saturn Vue have a timing belt or a timing chain? How do you check to see if a relay is good on a 1989 camaro? What transmission is in a k1500 z71 1997? Trying to find the belt tensioner for 1992 Lincoln Town Car It says it was made in June 92 no specific day got a unit that was for this car but the tension was down instead of up unit has large plate?