answersLogoWhite

0

Putting Auto Windows Back in the Guide Channels


On most vehicles, the windows got "out of track" because a screw or bolt holding one or more of the tracks has loosened, or broken.

The only way to correct this problem is to remove the door inner trim panel in order to get to the interior of the door where the guide channels and window operating mechanism is located.

Once inside, the track(s) have to be properly realigned, and the screws or bolts tightened to secure the guide channels in the proper location.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you change power window motor on 1991 dodge dynasty?

To change the power window motor on a 1991 Dodge Dynasty, start by removing the door panel to access the window mechanism. Disconnect the electrical connector from the old motor and unbolt it from the regulator. Install the new motor by securing it with bolts and reconnecting the electrical connector before reassembling the door panel. Finally, test the window to ensure it operates correctly.


Where is the PCV valve on a 1991 dodge dynasty 3.0 engine?

The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.


How do you put a 1991 dodge spirit driver side front window back on track?

Well I have no clue. go to a car store and ask them.


What are the size of the speakers in a 1991 Dodge Dynasty?

I believe its 6"


A diagram for a 1991 Dodge Dynasty with a 6 cylinder 3point 3 liter engine?

a diagram for a 1991 dodge dynasty w a 6 cylinder 3point 3 liter engine


Whats wrong 1991 dodge dynasty starts then dies?

what is a controller in 2.5 motor in a dodge


Does the dodge dynasty 1991 3.3 have an emergency fuel shut off?

No.


Where is the starter relay for a 1991 dodge dynasty 3.3 liter?

The 1991 Dodge Dynasty starter relay switch can be found in the fuse box. The starter relay switch will be in the third column, third from the top.


Will an automatic transmission from a 1991 Dodge Dynasty 3.3 interchange with a 1993 Dodge Caravan AWD 3.3?

NO.


Speedometer bounces on 1991 dodge dynasty?

A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.


Where is the fan speed relay on a 1991 dodge dynasty?

It is inside the ECM Module


Where is the computer located in a 1991 Dodge Dynasty?

The engine computer is behind the battery.

Trending Questions
What size fuse do you use for the cigarette lighter? What is the wheelbase of a 1954 chev truck 12 ton? Where is the oil pressure sensor sending unit on a 1990 Ford F-250 5.8 liter 5-speed gasoline truck? Is the 2008 Jeep Wrangler front wheel drive rear wheel drive or four wheel drive? Where can you purchase a hard top for 2001 Prowler? 2000 venture has a coolant leak plus you have replaced the water pump twice in the past year. Help? 1985 Chevy Monte Carlo STALLING? Ford Laser 1990 model that will drive fine than all of a sudden it stops than it wont start again than a day later it starts up again you checked for spark and there wasnt any? Why would a ford 292 engine fire but not run? How do you fix a 1995 Nissan Maxima power window that will not stay up? Will 94 s10 2.2 work in 96 s10 2.2? How do you change heater core in 1989 Buick Park Avenue? What is top speed of 1994 ford Thunderbird SC? How do i test and replace my blend door actuater and control valve on 2008 pontiac g5 for my car that stopped blowing heat? What temperature should your truck run? This question concerns a Ford Focus 1.8 Zetec E petrol engine. Do you know how much engine oil e.g. in litres or milliliters would have to be added to the engine to cause the oil level in the sump to? What is the prognostic and diagnostic uses of ECG? Where is the PCV valve lacoted 2001 ford expedition 5.4 liter v8? Do you have to have seatbelts on a 1972 Chevy pickup? You have 91 Chevrolet lumnia sputters when you give it the gas what could it be?