To fix the speedometer light on a 2000 Oldsmobile Intrigue, start by checking the vehicle’s fuse box for any blown fuses related to the instrument panel. If the fuse is intact, you'll need to remove the instrument cluster by unscrewing the necessary screws and disconnecting the wiring harness. Inspect the bulbs for the speedometer; if they're burned out, replace them with new ones. Finally, reassemble the cluster, ensuring all connections are secure, and test the light to see if it works.
yeah
With a scan tool.
Just remove the console and you can get to it.
To reset the PCS (Powertrain Control System) light on the dashboard of a 2000 Oldsmobile Intrigue, first, ensure that any underlying issues are repaired. Then, disconnect the negative battery cable for about 15 minutes to clear the trouble codes. Reconnect the cable and start the vehicle; the PCS light should be reset. If the light returns, further diagnostic work may be needed to address any persistent issues.
It depends on the year and options. Which year model are you asking about? On the 1996-2000 cluster, there's a light between the tach and speedometer for the cruise control (if equipped).
To reset the change oil light in a 2000 Oldsmobile Intrigue, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Then, turn the ignition off and back to the "ON" position to check if the light has reset. If the light is off, the reset is successful.
Start with the vehicle speed sensor the feeds the speedometer and odometer.Also look at the Brake/Speedometer problem associated with the Windstar recall for a leaking brake pressure switch
either the wiring needs to be redone, or the light bulb burnt out.
A 2000 Jeep does not have a speedometer cable.
Passenger side tail light corner is where my changer is
To turn off the change oil light on a 2000 Oldsmobile Intrigue, first, ensure that the oil change has been performed. Then, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has reset.
No