You have to purchase the powerwindow switch plate from somewhere like Autozone (about $100). Then with a very small flat tool, open the switchplate cover. Carefully remove the old burned out switch (remember where the plugs go - a red one and a white one I believe). Line up the new switch. Insert the new red and white plugs into the "outlets" on the car door switchplate (hard to explain but once you have it open and removed, you will understand). Insert the switchplate into the switchplate holder. Close the cover and you are done. It costed me about $150 the first time it burned out (with labor charges). The second time my husband and I replaced it for the cost of the switchplate only in about 5 minutes... if that. Good luck!
Autozone or Ebay
The power windows have a automatic reset circuit breaker. They are not fused.
The 1994 Chevrolet Camaro power window relay switch can be found inside of the driver side door. You will need to remove the door panel to access the power window relay switch.
pry out the control switch and disconnect the electrical connectors.install is reverse.
If none of them are working then you could have a master switch or relay defective.
How to replace a window and regulator on a 1998 checy malibu?
You will need to remove the door panel and see if the motor and/or the regulator is bad.
3600 rpm is the power of the Chevrolet Malibu automatic 1975 engine and its maximum speed is 180 km/h.
The 2009 Chevrolet Malibu is 5 ft. 10.3 in. (70.3 in.)1 one-touch power windows wide.
The 2001 Chevrolet Malibu is 5 ft. 9.4 in. (69.4 in.)12V front power outlet(s) wide.
The 2012 Chevrolet Malibu is 5 ft. 10.3 in. (70.3 in.)1 one-touch power windows wide.
The 2010 Chevrolet Malibu is 5 ft. 10.3 in. (70.3 in.)1 one-touch power windows wide.