You must remove the plastic panel located under the windshield wipers. There is about 5 or six torx screws under the hood and about as many Phillips screw hid by plastic covers across the panel.
On a 2000 Mercury Cougar the windshield washer fluid reservoir is at the front of the engine compartment , near the passenger side headlight
Yes , the 1999 Mercury Cougar is FRONT wheel drive
No , a 1994 Mercury Cougar is rear wheel drive
On a 2001 Mercury Cougar : The radiator is located in the engine compartment , at the front of the vehicle
On a Mercury Cougar : ( 1999 to 2002 model years are front wheel drive ) Older model years are rear wheel drive
To remove the front seat from a 1993 Mercury Cougar, first, slide the seat all the way forward to access the rear bolts. Use a socket wrench to remove the bolts at the rear of the seat, then slide the seat back to access and remove the front bolts. Disconnect any electrical connectors for seat adjustments if applicable. Finally, lift the seat out of the vehicle carefully.
It's grounded on the front of the Mercury Cougar frame next to the headlight assembly.
no it is defently rear wheel ================================================== That would depend on which model year , there have been rear wheel drive and front wheel drive versions of the Mercury Cougar
On a 2001 Mercury Cougar : The fuel pump shut off switch ( inertia switch ) is located in the drivers foot well behind the kick panel ( there is an access hole ) * the kick panel is the interior trim panel , in front of the front door , beside the persons feet
the front bearings on the 1989-thru-1997 ford thunderbird/mercury cougar cannot be changed, the whole front hub comes as one piece and have to be replaced as a single unit.
They are 5"x7" front ant rear, http://www.modifiedlife.com/1991-mercury-cougar-car-audio-wiring-schematic/
You can find a front door latch assembly diagram, for your 1996, Mercury Cougar from the manufacturer website. Many auto-parts websites will have the diagram.