To unlock a Jeep CJ7 glove box, you can try using a slim jim or similar tool to manipulate the locking mechanism through any gaps. Alternatively, if you have the key or can access the lock cylinder, you might be able to replace the lock or pick it. If those options fail, you may need to carefully remove the glove box door from its hinges or cut through the lock if necessary. Always consider the potential for damage to the vehicle when attempting these methods.
The heater blower motor resistor should be above the vent, behind and just below the glove box. It should have a three prong connector.
In is up under the dash on the drivers side on the firewall.
The glove department must be hooked on the three latches. If not, then the glove box will not close.
It's made of cardboard. Reach under the dash and rip it apart. Get it wet if you have to. Replace tit with an aftermarket plastic one.
The fuse panel for a 2003 Jeep Wrangler is located behind the glove box. The owners manual describes how to remove the glove box to access the panel. Removing the glove box is simple.
Look behind the glove box
Open the glove box, it is behind it.
The fuse box is behind the glove box (jockey box). Open the glove box and take it out by releasing strap on the right side. Pull glove box out and there is yours fuse box
The fuse box is behind the glove box door.
To open the glove box in a 1997 Jeep Grand Cherokee, locate the glove box door on the passenger side of the dashboard. Press the button or latch on the right side of the glove box to release it. Once the latch is disengaged, pull the glove box door down to access the contents inside. If the glove box is stuck, ensure there are no obstructions inside that may be preventing it from opening.
The cabin air filter is behind the glove box. You have to remove the glove box to get to it.
It's behind the glove box. Open the glove box and remove the strap on the right side, the box will fall right out.