First, fill all of the tires to the recommended or desired pressure. Insert key in the ignition. Turn the car to the "ON" position, but do not start the car. Remove thefuse panel cover located between the driver's side door and the dash. Push and release the rectanglar red button, marked "Reset". near the top of the panel. The "Change Oil" light will begin to flash. Push and release the red button again. The "Low Tire Pressure" light begins to flash. Now, push and HOLD the red button until you hear the chimes and the Low Tire Pressure light turns off. This should take about 3-4 seconds. Release the red button. Put the cover back on the fuse panel door. You have now turned off the Low Tire Pressure light.
No, a wheel bearing should not set off a low tire pressure light in a 1999 Oldsmobile Alero.
what does the engine light on the 1999 olds alero mean
To reset the low tire pressure light on a 1999 Oldsmobile Alero, you will typically need to locate the reset button, which is usually located under the dashboard or near the steering wheel. With the ignition turned on but the engine off, press and hold the reset button until the light blinks or turns off. This should recalibrate the system and reset the low tire pressure light. If this method does not work, consult the vehicle's manual for specific instructions or consider visiting a mechanic for further assistance.
894 for Sylvania.
what dose a 1999 Alero transmission look like.
1999 Alero how do i test ignition coil pack
turn off engine, and start again
how do you replace head lights on my 1999 oldsmobile alero?
How do you change rear wheel bearing on 1999 alero?
its below freezing temperature
Are parts interchangable from a 1999 alero to a 2001 alero
Show me a diagram of the starter location on a 1999 Oldsmobile Alero