When you put the van in gear the brake should pop up. You have to have your foot on the brake before taking it out of park.
If the parking brake cable is stuck, it is probably rusted in place. Try squirting WD-40 into the cable itself. If not, you will have to replace the cable.
The cables are corroded. You will need to replace the cables. To free them up you will need to disconnect them from the parking brake levers on both rear brakes.
Remove the 2006 Pontiac Montana wheel and tire. Remove the brake pad Springs. The brake pads will come off. Reverse the process to install the new brake pads.
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
Either your parking brake ( emergency brake ) is on or the brake fluid level in your brake master cylinder in your engine compartment is LOW
The brake light fuses can be found in the fuse box. The brake light fuse will be in the second column, fourth from the top.
Pull real hard upwards with both hands if it's stuck like that.... you need to remove the cover and pull/push a handle that will be near and will unlock it make sure to depress the normal brake
A lubricant on your 1995 Ford Mercury emergency brake can help to get it unstuck. Tapping on the emergency brake with a rubber mallet might also help.
how to change the master cylinder without taking it to a shop
Chevrolet Blazer parking brake can be adjusted with the adjustment screw on the parking brake pad. The parking brake can also be adjusted with the parking brake cable.
how do you adjust parking brake
A circle with the bottom quarter solid with jagged or wavy like lines on the top. The parking brake light comes on as well. I assume I have a brake problem but the book doesn't tell me.This light means low brake fluid level.