If your car has a tilt wheel it is operated by a short lever below the turn signal. Pull back on the lever to tilt the wheel.
To remove the steering wheel in a 1988 Chevy Celebrity standard version: !. Remove the screws that hold the horn pad in place then remove it. Unplug the wire at the connector. 2, If it still has the safety clip remove it. 3, Use the appropriate wrench to remove the nut from the steering shaft. 4. Use a steering wheel puller to loosen then remove the steering wheel. Reverse the instructions to replace the steering wheel. Steering wheel retainer nut should be 30 ft. lbs. torque.
The fuel pump on your 1988 Chevy Celebrity is in the fuel tank.
When you take the horn button off there is 1 big nut in the center of the steering wheel. Remove the nut and the safety snap ring. Then install a puller onto the steering wheel and pull it off. It will not just lift off with your hands.
The 1988 Chevrolet Celebrity uses distributor-less ignitions. Timing is controlled by the ECM, there is no provision for adjustments.
No there are shock absorbers on the rear.
You can find a 1988 Chevy steering component diagram at your local Chevrolet dealership. You can also find the steering component diagram in most Chevrolet service manuals.
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.
Metal.
The power steering pressure switch screws in. Simply unplug the wire harness, unscrew the old switch and screw in the new switch. Plug the wiring harness back in.
There should be a routing diagram under the hood. If it is the 2.8L V6 the diagram is on a guard above the belt between the power steering pump and the water pump.
R12 unless it's been converted.
PROPERLY remove air bag (if equipt), then remove nut holding steering wheel on and then use a steering wheel puller to remove it.