0
What else can I help you with?
How do you replace power antenna shaft on a 2001 firebird?
To replace the power antenna shaft on a 2001 Firebird, first, remove the interior trim panel around the antenna to access the assembly. Disconnect the power connector and unscrew the antenna from its mounting point. Then, pull the broken shaft out and insert the new one, ensuring it is properly aligned. Reassemble the antenna, reconnect the power, and test it to ensure proper operation.
How do you replace a 1994 Honda Prelude antenna?
You would need to get a tool to remove the notched chrome piece that holds the antenna mast, or carefully use pliers to unscrew it out. After you remove that, the antenna itself is held by a 10mm bolt. to get to it you'll need to open up the trunk lining near the antenna location and remove that bolt. Then, pull the antenna far enough to disconnect the antenna wire and power. Assuming the antenna motor is still functional, you can then replace the antenna mast with a new one. Or, you can install an aftermarket rubber antenna.
How do you replace an antenna on a 1997 Lumina?
If the antenna is broken off at the base the entire base will need to be replaced. In order to do this the upper dash pad and the cowl will have to be removed so the three bolts will be exposed to remove the broken one.
How do you remove the antenna mount in order to remove the fender on a 2000 dodge neon?
Remove mast. Inside car (pass. site): disconnect antenna cable,(you may have to remove door-sill and kick panel) Outside: remove tire (makes it easier to) remove inner splash shield, remove mounting screws and pull antenna base and cable from under fender. Note:there is a rubber grommet going into the car and it may be hard to remove, this is not a big deal if you are replacing it with a new one. (part of a new antenna)
How do you change a power antenna on a 1996 Oldsmobile 88 ls?
To change the power antenna on a 1996 Oldsmobile 88 LS, first, disconnect the negative battery terminal for safety. Then, remove the interior trim panel to access the antenna's mounting bolts, typically located in the rear quarter panel. Disconnect the antenna's wiring harness and unscrew the old antenna from its mount before installing the new one. Finally, reassemble everything in reverse order and reconnect the battery.
How do you remove the power antenna motor on a Mercedes 500 sl?
Its best to remove everything from the trunk! The driver's side remove the [6 CD] changer from its metal support by removing the two Phillip's shrew's. Remove the CD changer support bracket [2. 8mm] bolts then remove the clips from the trunk lining and remove the trunk lining. You will now see the antenna motor assembly. Unscrew the top of the antenna from the rear fender [13 mm spanner]. there is one 10 mm shrew holding the antenna onto the metal chassis of the trunk. Remove the evaporation system charcoal canister from the wheel well by pulling it [up] to remove it from the clips. this must be done to create clearance to remove the antenna unit. Then remove the antenna cable from the antenna unit.
How do you replace a broken antenna on a 1993 Isuzu Trooper?
I did this on a "96" Trooper for a power antenna. Remove the lining in the wheel well above the tire. You should be able to find any replacement screws or clips in your local auto parts store for reinstalling, if needed. You will need to turn your tire all the way to one side for better access of some screws and the antenna itself. There will probably be a couple of screws holding the power antenna unit to the fender. Remove the screws anchoring the power unit. At this time, you probably want to disconnect your car battery. When you open the power unit to reveal the inner workings, the power winder can automatically activate. There will be no way to stop it without disconnecting the battery. You will want to examine how the power unit is wound and copy it with the new antenna. Good luck.
Where is the power antenna fuse located in a 1995 Buick Riviera?
In a 1995 Buick Riviera, the power antenna fuse is located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove a cover panel. The specific fuse for the power antenna is typically labeled in the fuse box diagram, which can help you identify the correct one to check or replace.
How can you send your own tv signals through antena locally?
Yes, but it is illegal. You would need a power amplifier and remove the transformer from the antenna if it has one.
How do you replace the power antenna mast on a 1996 Mitsubishi 3000 GT hardtop convertible?
To replace the power antenna mast on a 1996 Mitsubishi 3000 GT hardtop convertible, first, disconnect the negative battery terminal to ensure safety. Remove the interior panel or trim that covers the antenna assembly, then unscrew any bolts or fasteners holding the antenna in place. Once exposed, carefully pull the old mast out and replace it with the new one by following the same steps in reverse. Finally, reattach the panel and reconnect the battery.
How do you get to the power antenna on a Lexus rx 300?
Just remove the nut on the outside, turn your radio on (to initiate antenna rising) and pull out the antenna as it is pushed out. Inspect the plastic cable for damage (if it is broken then there are going to be pieces left in the motor, in this case you will have to remove it from the trunk and open it up to remove the pieces). If it is just the worn out teeth as expected, replace it by inserting the cable of the new one with teeth facing forward until it stops, then turn off the radio and the motor will pull in the antenna. Quick fix should take you no longer than five minutes. Good luck.
How do you replace a broken automatic antenna on a 94 Honda Accord with a fixed antenna?
That's easy, I did the same job to my 90 accord. First buy a fixed antenna, I went to radio shack, something like $12, instead of $200+ for the power antenna from Honda.. In the trunk, on the side of the antenna, pull back the trunk liner but be careful not to break an clips. once the trunk liner is out of the way, you'll see what tools you'll need, and what nuts to turn. The new antenna will have all of the parts you need, find one that fits the fender the best. It is a relatively easy job, self explanitory once you expose the antenna from under the trunk. I completely took the old power antenna assembly out of mine. It's pretty self explanatory. Remove old antenna assembly, install new fixed antenna to quarter panel, plug in your antenna cable, replace trunk liner (carpet).
