0
To identify the transmission in your 1989 Ford Bronco II, you can check the Vehicle Identification Number (VIN) located on the dashboard or driver's side door jamb, which can indicate the original transmission type. Additionally, you can look for the identification tag on the transmission itself, typically found on the passenger side, which contains the model number. The Bronco II commonly came with either a C5 automatic or a manual transmission, so knowing the specific model will help narrow it down. Lastly, you can consult the owner's manual or service manual for further specifications.
What else can I help you with?
How do you identify auto trans 89 bronco full size?
Dealership can tell you. There's a good chance you have the C6 transmission.
How do you check the transmission fluid in your 89 ford bronco II?
start up your bronco,let it idle, pull the tranni dip stick and see if there is nay oil in the tranni
How do you remove the hydraulic clutch cylinder 89 ford bronco II?
Remove the exaust pipes. Remove the transmission. It is located inside the bell housing section of the transmission.
Will 85 ford bronco tailgate fit 89 ford bronco?
Yes. The Bronco body style didn't change again until after 1989.
Why wont Ford bronco transmission will not engage?
Be careful on this. I did it to myself . I install my transmission back on my 89 bronco and found out I didn't lock in the converter right and damage it. Cost me an extra $700 to repair the pump and new converter had the same systems as you.
Where is the transmission dipstick in an 89 Ford Bronco?
for manual trans. it is behind the steering wheel, for automatic it is on the left side of engine compartment near the engine.
What type of trans does your 89 bronco ii have?
vehicle has a aoutomatic transmission
Where is the starter an 89 ford bronco?
Underneath, back of engine, passenger side.
Can a headlight from a 92 ford bronco work on a 89 ford bronco?
No, the front end of 92 - 96 Broncos is completely different than 87 - 91 Broncos.
What is the fuel pressure on a 89 ford bronco II 2.9?
I believe that is 30 to 40 PSI
Where is the starter at on a 89 Ford Ranger?
attached to your transmission
89 Bronco II and have had the transmission rebuilt twice since you had it and one prior to you owning it Is this a common issue on all Bronco II?
I also have an 89 bronco II and I'm getting g ready to replace the transmission for the first time. I looked into rebuilding it and through various websites devoted to the bronco II I found out that the transmissions aren't that good. They were made by Mitsubishi and are really more suitable for compact cars than midsize SUV's. A good resource is www.rangerstation.com. It's a ford ranger enthusiast website that also has a plethora of info about the bronco II. Hope this helps.
