0
To install an ERG valve on a 2003 Pontiac Aztek, first, disconnect the negative battery cable to prevent electrical shorts. Remove the air intake duct for better access, then unbolt the old EGR valve from its mounting. Clean the mounting surface, install the new valve with a new gasket, and reattach the air intake duct. Finally, reconnect the battery and check for proper operation.
What else can I help you with?
Will rims off a 2004 Pontiac grand am fit a 2003 Pontiac Aztec?
Yes
How do you change spark plugs on a 2003 Pontiac Aztec?
fuctifino
How many gallons does the tank in a 2003 Pontiac Aztec hold?
18 gallons found at http://www.new-cars.com/2003/pontiac/pontiac-aztek-specs.html
Where is the egr valve located in a 2003 Montana?
The 2003 Pontiac Montana EGR valve is located on the firewall. The valve will be on the driver side of the firewall.
Where is the idle air control valve on 3.8 liter 2003 Pontiac Grand Prix?
Where is idle air control valve located on 2003 Pontiac Grand Prix GT, 3.8 liter 6 cylinder?
Where is a cabin filter located on a 2003 Pontiac Aztec?
In your glove box there is a small access door-at least that is where it is on my 2002
Where is the PCV valve located on a 2003 Pontiac Vibe?
It is at the rear driver side of the valve cover. There is a hose leading from it to the Throttle Body.
How do you install a PCV valve on a 2003 escape?
To install a PCV valve on a 2003 Ford Escape, first locate the valve, which is typically found on the valve cover. Disconnect the hose connected to the old PCV valve and twist it counterclockwise to remove it. Install the new PCV valve by pushing it into the valve cover and securing the hose back in place. Finally, ensure everything is connected properly and check for any leaks before starting the engine.
How do you know if somthing is wrong with your front passenger axel 2003 Pontiac Aztec?
if you have a bad axle they will usually make a clicking noise when turning
For a 2003 Pontiac Aztec where is the radiator drain so you can flush the coolant system?
you have to take off the cover then it is on the driver side, plastic butterfly bolt
Where is the PCV Valve on a 2003 Ford F150 V64.2L?
PVC Valve Removal & Installation # Disconnect the oil separator hose from the PVC Valve. # Remove the PVC Valve from the grommet in the crankcase. Grasp the valve and gently remove it from the grommet in the passengers side valve cover. Remove the valve from the hose by carefully twisting it out. # Inspect the grommet for deterioration. To Install; # If necessary, replace the crankcase grommet. # Install the PVC Valve. # Install the hose.
To install an aftermark radio into a 2003 Pontiac Grand Am do you need a chime installer?
No But you will lose your Chimes "not needed anyway"
