0
How do you install a motor for the power window on the drivers side of a 1997 Oldsmobile Aurora?
To install a power window motor on the driver's side of a 1997 Oldsmobile Aurora, first, disconnect the vehicle's battery to ensure safety. Remove the door panel by unscrewing any visible screws and carefully prying off clips to access the window motor. Disconnect the wiring harness from the old motor, unbolt it, and then replace it with the new motor, securing it in place. Finally, reconnect the wiring, reassemble the door panel, and reconnect the battery to test the new motor.
What else can I help you with?
On the 1997 Oldsmobile Aurora what would cause all 4 power windows to stop working at the same time?
Fuse, wiring, connector, drivers side window control switch.
Where is the fuse located for power window on 1998 Oldsmobile Aurora no windows work?
under the back seat
Where is the third brake light located on the 1995 Oldsmobile aurora and does it work?
mine on my 97 is on the rear window deck.
How do you repair the rear door windows on the 2001 Oldsmobile Aurora when they no longer stay up?
you need to change the window regulator
Is there a relay for drivers power window on a 1998 aurora if so where is it located?
under the seat in the fuse box it should be the fuse directly above the window relay
How do you attach the window in a 1996 Oldsmobile Aurora?
You have to remove the door panel and attach the new window to the window frame this is very easy but it is time consuming and make sure you have no air leaks before you put the door panel back on
What causes the drivers side window to fall down on a 1995 Oldsmobile Cutlass Supreme?
the window regulater has a nylon tape that runs the window up and down. the tape can be purchased fromm the parts store
How do you install a new window regulator on a drivers door of Pontiac Montana?
turn bolts to the left, install regulator, turn bolts to the right
How do you install a new window regulator on a mgzr drivers door?
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
How do you change the window regulator on an Oldsmobile aurora?
Start by disconnecting the negative battery cable, battery is under the rear seat. then remove all fasteners to the door panel,the panel slides up. Remove the plastic protector and remove the bolts that hold the regulator/motor then replace and reverse the order to install.
When starting 2002 Oldsmobile aurora rear power window goes down?
A crossed ignition wire and a power window wire could cause this problem. Check the wiring below the dashboard. You should be able to find the bared wires.
How would one change the drivers side window motor on a 1985 GMC 1500 pickup?
i need a diagram to install a window motor on a 1980 gmc truck
