0
To install an orifice tube in an Oldsmobile Intrigue, first, ensure the vehicle is off and the air conditioning system is discharged. Locate the orifice tube, which is typically found in the high-pressure line near the condenser or evaporator. Remove the old tube by disconnecting the line fittings, then install the new orifice tube, ensuring it is properly seated. Finally, reconnect the line, recharge the A/C system, and check for any leaks.
What else can I help you with?
Where is orifice tube on 99 Oldsmobile intrigue 3.5L?
This orifice tube is by what they call the condenser, usually found by the core support
Is there a transmission dipstick on a 1999 Oldsmobile Intrigue?
The 1999 Olds Intrigue does have a dipstick. Use a funnel to add fluid as needed into the dipstick tube.
Where is the location of the orifice tube on a 01 Oldsmobile intrigue?
The orifice tube on a 2001 Oldsmobile Intrigue is located in the air conditioning system, specifically in the high-pressure line. To access it, you'll typically need to locate the aluminum line that runs from the condenser to the evaporator. The orifice tube is usually situated near the evaporator, often within the engine compartment, and may require some disassembly of nearby components for easier access.
How do you install an oil dipstick tube on a 1973 Oldsmobile omega 350CID?
To install the oil dipstick tube on a 1973 Oldsmobile Omega with a 350 CID engine, first ensure the engine is cool and clean the area around the dipstick tube opening. Insert the dipstick tube into its designated hole in the engine block, ensuring it seats properly. Secure it with the retaining bolt or clip if applicable, and then check that the dipstick can be easily inserted and removed. Finally, verify that there are no obstructions and that the tube is properly aligned.
Where do you put transmission fluid in a 1998 Oldsmobile intrigue?
To add transmission fluid to a 1998 Oldsmobile Intrigue, first ensure the vehicle is on a level surface and the engine is running. Locate the transmission dipstick, which is typically found near the back of the engine compartment, and remove it. Use a funnel to pour the appropriate type of transmission fluid into the dipstick tube, checking the fluid level with the dipstick to ensure it is within the recommended range. Be cautious not to overfill.
How do you install inner tube in a tire?
remove old valve & install new tube simple
Can you install a tubeless tire on a tube type rim?
No, you cannot install a tubeless tire on a tube type rim.
Where does the oil go in a ninety-eight Oldsmobile?
in the filler tube on engine
How do you stop water infiltration from getting in to the heater AC fan on a 2001 Oldsmobile Intrigue when you have replaced it twice?
Make sure the water is from the radiator. When an AC is functioning properly, water condenses on the coil and is SUPPOSED to drip down a drain tube below the car. If the tube is blocked the condensate water could be backing up and causing the problems you describe. Check the drain tube when the AC is running. Make sure water is dripping out of the drain tube. If the tube is blocked, run something through to see if you can break the obstruction loose.
1994 Chevy truck 2500 How do you locate remove and install an oraface tube?
What orifice tube?
What is the best way to choose and install a tire tube for a bike?
To choose and install a tire tube for a bike, first, determine the correct size by checking the tire sidewall. Then, select a tube that matches the size and valve type. To install, deflate the tire, remove the wheel, and insert the tube into the tire. Carefully align the valve with the hole in the rim before inflating the tube slightly. Finally, reattach the wheel and inflate the tube to the recommended pressure.
How do you put freon into an 1999 Oldsmobile Intrigue?
i have to put freon R-134 into my 99 3.8 L, its in the center rear, (away from headlights). you can tell because there is a black nob hooked up to the silver in color tube. with the do it yourself stuff its hard because its in an akward position but wasnt realy designed for it i guess. just un screw the black nob on the silver tube that is center rear under the front hood.
