answersLogoWhite

0

What else can I help you with?

Related Questions

What is an EC-TS for a 1998 Saturn SC2?

Engine Coolant Temperature Sensor.


How do install rear speakers in a Saturn sc2?

You must remove the rear package tray.


Where can I get a diagram of the intake sensor on a 1996 Saturn SC2?

The air intake sensor is a resistor that goes to the PCM. A schematic can be found in a service manual


How do you install a JVC CD player into a 1995 Saturn SC2?

Buy a trim kit and harness adapter from crutchfield.com


Why does your 97 Saturn SC2 start rough run fine then stall when you put it in gear?

vacuum leak,map sensor


What does trouble code P0708 in a 2002 Saturn SC2 mean?

Trouble code P0708 means:Transmission range sensor circuit high input


Dexron 6 transmission fluid do you use in a Saturn 2001 sc2?

dexron6 are type transmission oil for Saturn 2001 serial sc2


What are some characteristics of the Saturn SC2?

The Saturn SC2 automobile was a part of the Saturn S series automobiles that was around from 1990 up until 2002. The SC2 looked similar to a Nissan 240 SX and the model was manufactured around 1994-1995.


Will seats from a 98 Saturn sc2 fit in a 94 Saturn sc2?

Yes. All Seats from Saturn S-series cars are compatible from 91-02, except for the back seats. For example: You cannot use an SC1 back seat in an SC2.


Why is my 1996 Saturn SC2 overheating?

One of the most common issues related to overheating on the s-series is a malfunctioning engine coolant temp sensor.


How many miles can you put on a 2001 Saturn SC2?

i have a 1997 Saturn sc2 410xxx miles my friend is at 560xxx on his sl1 if you treat a Saturn well it will last a lifetime if you don't you will cry


How do you replace coolant temperature in 1999 Saturn sc2?

On the back of the engine......meaning the right side if looking at the vehicle (by the battery), The upper rad hose goes into the cyl. head. Below that in the middle of the head is a sensor with two wires going to it Unplug it and remove the sensor with a 13 mm deep socket...Install the new sensor and plug back in