The air intake sensor is a resistor that goes to the PCM. A schematic can be found in a service manual
diagram of a nock sensor in a 300zx 1996
See the Related Links for "radio diagram" to the left for the answer.
there is no cam sensor on any 1996 saturn- i presume there is a code p0341 set- check the 1/4 plug wires, plugs, and coils
The coolant temperature sensor is on the rear of the engine, towards the top near the air intake hose. Move the air intake hose and you will see a single wire connector going to small sensor. The CTS is located on the block on the cylinder 4 side of the motor.
The sensor is threaded into the coolant passage in the back of the cylinder head.
The oxygen sensor on a Saturn can be found in the exhaust manifold at the front of the engine. It simply unscrews and unplugs. 5 minute fix!
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE
under the intake manifold
http://youtube.com/watch?v=JC0U53w_Htk
The IAT (intake air temperature) sensor should be in the air intake snorkel between the MAF (mass air flow) sensor and the throttle body.
In the big rubber air intake tube , not too far from the throttle body