0
It is a lengthy project if you do it correctly. You have to just about take the entire tailgate apart piece by piece. I started by removing the tail gate and putting it on some padded saw horses. From there, you just have to keep removing bolts until you get it broken down. The reason it is so difficult is there is a small tab positioned so that you cannot remove the latch -- you will likely see it early on. It is located right in the latch handle area. I took a short cut at this point. You don't have to but it was "a big time saver."
After looking at the tab for a while and procrastinating about taking the tailgate apart, I had my body man take a cutting wheel and remove the tab. You cannot see this when the latch is in place -- it appears to be a security enhancement, not a requirement for looks or operation of the latch. Anyway, it saved a couple hours of work and works/looks fine.
What else can I help you with?
How do you replace a tailgate handle on a 2007 Chevy avalanche?
To replace the tailgate handle on a 2007 Chevy Avalanche, first, open the tailgate and remove the screws holding the handle in place, typically located on the inside. Next, disconnect the linkage connected to the handle and gently pull the handle out. Install the new handle by reversing the process: insert it into place, reconnect the linkage, and secure it with the screws. Finally, test the new handle to ensure it functions properly before closing the tailgate.
How do you replace tailgate handle on Chevy 2000 s10?
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
How do you replace a tailgate handle on a Chevy Colorado?
How do I take off the handle to put a new one on a chevy colorado 2005
How do you open the tailgate on a 1999 Chevy Tracker?
To open the tailgate on a 1999 Chevy Tracker, locate the tailgate handle located between the rear lights. Pull the handle upward to unlock and release the tailgate. If the tailgate is stuck, ensure that the vehicle is in park and check for any obstructions or issues with the locking mechanism. If necessary, you may need to use a key to unlock the tailgate if it is locked.
Why tailgate will not stay shut when closed on 02 avalanche?
If the tailgate on your 2002 Chevy Avalanche won't stay shut, it could be due to a malfunctioning latch or catch mechanism that isn't securing properly. There may also be issues with the tailgate cables or hinges that prevent it from closing fully. Additionally, debris or damage to the tailgate's rubber seals could interfere with a proper seal. Inspecting these components can help identify the specific issue.
How can you open the tailgate with a broken latch on a 2005 Chevy avalanche?
If the tailgate latch on your 2005 Chevy Avalanche is broken, you can try using a flathead screwdriver to pry open the latch mechanism from the inside, if accessible. Alternatively, you can remove the tailgate cover to access the latch assembly directly and manually release it. If these methods don't work, consider using a slim jim or a similar tool to manipulate the latch. However, if you're unsure or uncomfortable with this approach, it might be best to seek assistance from a professional mechanic.
How do you open the tailgate on a 1995 Chevy pickup Tailgate handle broke and I have a cover over the bed of the truck I don't have access to the inside rear of the tailgate because of the cover?
If you look where the handle goes you will see 2 rods. Just squezz them together. Are use a screewdriver to pry them towards each other.
How do you open broken tailgate on 05 Chevy Avalanche?
You have to take off the plastic surround around the handle for the tail gate then pull the two silver rods toward each other or toward the handle and the gate will come down. Most likely the spring has broken or the lock stop and the kit to replace the whole latch assembly is about $35.00.
How do install a new door handle for a 95 Chevy?
go to autozone,buy a handle remover/install tool.very simple and direct.
How do you replace cargo box light bulb in 2003 Chevy Avalanche?
To replace the cargo box light bulb in a 2003 Chevy Avalanche, first, open the tailgate to access the light assembly. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and twist it clockwise to secure it. Finally, snap the lens cover back into place and close the tailgate.
How do you install a door handle?
I have a 1996 Chevy extended cab cheyenne pickup. i need to know how to install a door handle on the passenger side.
Where is the jack handle for the Chevy avalanche?
The jack handle for the Chevy Avalanche is typically located in the storage compartment beneath the rear seat. To access it, lift the rear seat bottom and look for a small compartment or tray where the jack handle and other tools are stored. If it's not there, check the owner's manual for specific details related to your vehicle's model year.
