0
Loosen all the bolts on the alternator and push down on the alternator and the belt will be loose and you can take it off, to reinstall you put new belt around the water pump and crank pulleys and then put it over the alternator pulley and pull up on the alternator and tighten the bolts back up and you should have a 1/2 " play in the belt when you push down on it, if you have more than that you need to unloosen alternator bolts again and pry the alternator up with a large screwdriver and re-tighten the bolts again and recheck.
What else can I help you with?
How do you install a heater core on a 1985 Oldsmobile Cutlass Supreme?
cutlass supremes are so baller
How do you install a crankshaft sensor on a 1993 Oldsmobile Cutlass Supreme?
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
How do you install starter in 1993 cutlass supreme?
Stick the starter in the cutlass supreme.
How do you replace water pump in 1986 Oldsmobile cutlass supreme?
To replace the water pump in a 1986 Oldsmobile Cutlass Supreme, first disconnect the battery and drain the coolant from the radiator. Remove any components obstructing access, such as the serpentine belt and the alternator, if necessary. Unbolt the water pump from the engine block, clean the gasket surfaces, and install the new pump with a new gasket. Reassemble all components, refill the cooling system with coolant, and check for leaks after starting the engine.
How do you install a rear view mirror on a 1996 Oldsmobile Cutlass Supreme?
go to the parts store and get a rear view mirror mounting kit and follow the instructions to a T.
How do you change the alternator on a 1994 Oldsmobile cutlass supreme 3.4l?
I've never changed an alternator on that particular car. But, on most cars you just loosen the belt tensioner and take off the belt. (Make sure you know how your belt is routed.) Then, undo the electrical connections to the alternator. Next, take off the alternator bolts. Last, do everything in reverse to install your new alternator. Hope that helps. God bless www.myspace.com/armthedriver
How do you install a fuel pump in a 1998 Oldsmobile Cutlass?
Remove fuel tank for access
How do you remove alternator from 1989 Oldsmobile cutlass sierra?
IT is only about 3 bolts release tension losen bolts unplug wire follow step in reverse install new one (disconnect battery first
How do you change a blower motor on a 1995 cutlass supreme?
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
How do you change a oil pump in a 1972 Oldsmobile cutlass supreme?
Remove the oil pan, unbolt the pump, install the new pump,the pump drive is off the bottom of the distributor and must be aligned to go in properly.
Do you need to know what the torque would be to find out if the idler tension pulley has to be torqued when you install the serpentine belt on a 1995 Oldsmobile Cutlass Supreme?
there is not a specific torque for the idler pully. tighten it up with a ratchet and it will not loosen up
Changing starter 95 Oldsmobile cutlass supreme 3.4?
To change the starter on a 1995 Oldsmobile Cutlass Supreme with a 3.4L engine, first disconnect the negative battery cable to prevent electrical shorts. Then, remove any components obstructing access to the starter, such as the air intake duct. Unbolt the starter from its mounting location and disconnect the wiring harness. Install the new starter by reversing the removal steps, ensuring all connections are secure and the battery is reconnected last.
