cutlass supremes are so baller
Begin by removing the serpentine belt from your Oldsmobile Cutlass. Remove the tensioner pulley retaining bolt. The retaining bolt will be in the center of the pulley. Reverse the process to install your new belt tensioner.
Stick the starter in the cutlass supreme.
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
go to the parts store and get a rear view mirror mounting kit and follow the instructions to a T.
Remove the power steering hose. Remove the power steering belt. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump on your 1985 Oldsmobile Cutlass.
Remove fuel tank for access
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
Remove the oil pan, unbolt the pump, install the new pump,the pump drive is off the bottom of the distributor and must be aligned to go in properly.
Take the gas tank down as the pump is inside the gas tank.
Replacing the brake pads on your 1982 Oldsmobile Cutlass is quite easy. Remove the brake pad Springs and caliper. The brake pads will come off. Reverse the process to install the new brake pads
A Hanes or chilton manual
Seems silly.. take out the old one, and install the new one. Pull the carpet away from you in the trunk by your brake lights, and you'll see 3 screws with plastic wingbolt lookin things. Unscrew all of them, and you can pull the entire assembly out.
how do you install a serpentine belt on a 1996 corsica?
sounds like pump is going, install new pump
Remove the serpentine belt from the alternator. Remove the positive battery cable from the battery. Remove the cables from the alternator. Remove the wiring harness. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
how to install a serpentine belt on 1989 f250 diesel 7.3l
Disconnect negative battery terminal. Loosen the serpentine belt - loosen the tensioner. Disconnect the alternator connections at the terminals. Slip the serpentine belt off the alternator pulley and pull the alternator out. Install is reverse.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
Remove the wiper arm from your 1999 Oldsmobile Cutlass wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
remove steering wheel with a puller, remove turn signal switch, remove tilt steering spring by pushing down and turning slightly counter clockwise, this should give you access to the torx screw . remove this screw and slide ignition lock cylinder out
Its 2 9/16 bolts and 2 wires... Its 2 9/16 bolts and 2 wires... Its pretty easy if its a Supreme
Remove the negative (black) cable from the battery. dissconnect any power wires running to the starter. remove two bolts located on the starter. Have someone help so they can hold the starter while you loosen bolts. When putting starter back in reverse procedure.
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.