you will see a small hole directly below the key cylinder turn the ignition to "run" not "on" put a wire or punch in the whole to disengage the retaining pin while pulling on the lock cylinder at the same time. ALSO DISCONNECT THE NEGATIVE BATTERY CABLE AND AS A PRECAUTION DISARM THE AIRBAG.
how to change igntion lock
Why won't the keys in the ignition turn on a 1992 grand marquis?
On a 2000 Mercury Grand Marquis : The firing order is ( 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 ) The engine cylinder locations are numbered : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis , 4.6 It has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils
I got a friend whose key can't turn the ignition on her 2000 Pontiac Grand Am. She can't get the steering wheel to unlock either.
firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis
insert key into lock cylinder and rotate to accesary or run and insert small pick into access hole located directly above or below cylinder housing and it release out!
where is the ignition control module located on mercury marquis
To remove the ignition switch from a 1986 Mercury Grand Marquis, first, disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the screws and carefully pulling it apart. Next, locate the ignition switch attached to the ignition lock cylinder; disconnect the wiring harness and remove the mounting screws. Finally, pull the ignition switch out to complete the removal process.
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis
firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis
One for each cylinder