Pretty easy to do actually, Most Jeeps have holes in the bumper already, so you can mount them there, there are alot of ways to mount lights, just decide where they'd look best and use a 35 torx to take off anything in the way
with wires
Fuse nineteen goes to the fog lights. The fuse box as well as the manual should have a diagram of the fuse box.
turn on the running lights and pull out on the multi switch.
take the battery off and then fix the light swish
headlamp switch
The 2002 wrangler has a switch on the turn signal multifunction unit. You must pull out the end of the turn signal, and the low beam must be on; it won't work with the high beams on.
need diagram to install 2000 Honda civic syder fog lights
Fog lights use special brackets which sit recessed on a 2001 Chevy Cavaliers bumper. To install the fog lights mount the units into the bumper brackets. Then splice the fog lights into the existing wire harness. Use a switch if necessary.
Between the battery and the valve cover on the firewall.
yes you can install factory fog lights on a non fog light car,however, there may be some fabricating of brackets to mount the fog lights to.also you must either install your own switch or wire them directly into your parking lights.
By buying fog lights and installing them.
Where you can buy a new lens for your fog light will primarily depend on the type of fog lights you have. If you have lights that are not stock, then you will need to determine the manufacturer of the lights and contact them. If you have fog lights that came on the jeep from the factory, things are a little easier. Your local Chrysler dealership's parts department should be able to order you a new lens, but it may be as part of a whole new fog light assembly. Speaking from experience, removing and replacing the whole stock fog light is pretty simple. There is one bolt on the light holding it to the front bumper, and the wires have a disconnect inside the fender that the light is closest to. Hope this helps.