with a mechanic
The 2002 Toyota Tacoma ignition coil is located on the firewall in the engine compartment. The coil will be on the drivers side of the firewall.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
Each spark plug has it's own ignition coil, they are on the spark plug itself. Unplug the ignition coil connector, remove the bolt holding the coil in place, pull the coil off of the spark plug and out of the valve cover. Install the new coil.
Where is the igniyion coil on a2002 mazda protege
Remove the plastic engine covers. You will then see the coil packs. Unloosen the four screws, pull coil pack STRAIGHT OUT. Install is the reverse of removal.
The 2002 Ford Taurus V-6 engine ignition coil can be found on the firewall in the engine compartment. The coil is located on the drivers side of the firewall.
It is most likely the pick-up coil "inside the distributor".It could also be the coil or the ignition module.
take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.
I understand it is by the coil. You have to remove the dog house, the coil is on the right side of the engine if you were sitting in the drivers seat.
follow spark plug wires back to other end & that is your coil
Unplugging the coil wire and not grounding it, yes that can damage the coil.
the coil is mounted to a bracket with rivets. the bracket is mounted with 2 bolts. unbolt the bracket and drill or grind the rivets out . the new coil comes with mounting screws.