0
What else can I help you with?
How to replace a serpentine belt on 1994 buick lesabre?
replace tension put it on
Why does your 1992 buick lesabre make a loud ticking noise?
there is a rattling noise in the area of the serpentine bell
Is the water pump on a 2000 buick lesabre 3.8l engine chain drivien?
no its driven by the serpentine belt
How do you change a serpentine belt on a 1995 Buick LeSabre?
There is a special tool I saw in a pawn shop that is just for that.
What causes the serpentine belt to break on a 1987 Buick LeSabre?
Old age Frozen or misaligned pulley
Where is the tension adjustment for a 1995 Buick lesabre serpentine belt?
There is no tension adjustment. Tension is automatically adjusted by the idler pulley.
How do you charge the battery in the Buick LeSabre without removing it from the car?
Hook it to a battery charger.
How can you route the serpentine belt to bypass the AC compressor on a 1993 Buick lesabre What size belt do you use?
I had a 1995 buick lesabre and the A/C compressor went out in the winter time. I waited until spring to replace the compressor. In the mean time, I used a Dayco 72.10 inch belt and bypassed the A/C compressor and it runs fine.
How much will it cost to replace serpentine belt on 95 Buick lesabre?
It can cost between $14 and $30 to replace a serpentine belt on a car. The price can raise to $40 or $60 if a person has it done at a car shop.
Where is the water pump located in a 1992 Buick lesabre?
In a 1992 Buick LeSabre, the water pump is located at the front of the engine, typically mounted on the engine block. It is driven by the serpentine belt and is positioned near the timing cover. To access it, you may need to remove the serpentine belt and possibly other components, depending on the specific engine configuration.
Why would a 92 Buick LeSabre not run turn over after Serpentine belt shreds?
probably damaged the crank sensor, or the tangs on the harmonic balancer
How do you replace the starter on 92 buick lesabre?
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
