0
What else can I help you with?
how do you find a fuse number on a hanging red and black wire and plug on drivers side in back of an Chevy express 2012 cargo van?
i have a hanging red and black wire in a plug on the inside in back of my 2012 express cargo van on the drivers side. it is shorted. i need too know what fuse number to replace to make it hot again
Do the back of the Chevy Express van bench seats fold down?
Unfortunately the Chevy Express of 96 TO 02 does not have folding bench. I don't know for others years.
Where is the jack in a 2002 Chevy Trailblazer?
under the back seat.. drivers side
How do you change a tail light assembly on a Chevy Malibu?
open trunk and pull back lining, take off the nuts that hold assembly in, pull assembly out.
How do you put the headlight assembly back on a 2000 Chevy Blazer?
open the hood. in back of headlight assembly there are two metal slides with pull tabs. pull them up then wiggle the headlight assembly. it should fall right out. with it out you can get at the bulbs.
Were is the distributor cap located on a 1999 Chevy Venture?
the 1999 Chevy venture does not have distributor cap, he has a electronic module assembly, assembly is module and three coils, they are located on the top of the engine, back in the medium near of the firewall.
Where is the crankshaft sensor on a 2001 Chevy Express van 1500?
The 2001 Chevy Express Van crankshaft sensor will be on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
Where is PCV valve location for a 2000 1500 Chevy?
It will be on the back top of the drivers side valve cover.
Where is the PCV valve on a 2003 Chevy Suburban?
Its in the drivers side valve cover in back near the firewall
How do you assembly the back brakes in a 1983 Chevy one half ton pick up?
Plesae cancel this reqeust
Where is the front abs sensor located on a 1996 Chevy Cavalier?
it should be located right on the back of the wheel assembly
How do you replace cigarette lighter assembly in 2001 Chevy Prizm?
Remove the retaining ring on the top of the cigarette lighter assembly. Pull the cigarette lighter assembly out and remove the wiring harness from the back of the assembly. Reverse the process to install the new cigarette lighter assembly.
