;how to remove drivers door panel to repair door restrictor
remove the door panel
To replace the drivers inside the door handle of a 2001 Toyota Sienna, first, remove the door panel by unscrewing any screws and carefully prying it off. Next, disconnect the wiring harness and remove the old door handle by unscrewing it from its position. Install the new handle by securing it with screws, reconnect the wiring, and finally, reattach the door panel, ensuring everything is properly aligned. Make sure to test the handle function before fully securing the door panel.
The 4 door fuse panel is under the dash on the drivers side The 2 door fuse panel is in the drivers end of the dash , the fuse panel cover is visible with the drivers door open
My 2005 Explorer xlt tire is 235/70/16. Just look at the label pasted on the drivers door panel where the door hinges are located.
In the drivers footwell , it is the interior trim panel just in front of the door
The drivers side kick panel is in the drivers footwell , just ahead of the drivers door It is an interior trim panel by the drivers left foot
The drivers door panel has 12 retaining clips. Pry outward on each clip, one at a time. Remove the inside door handle retaining screws.
take the door panel off...its usually the norm..
It's the interior trim panel in the drivers footwell just in front of the drivers door
In the 4 door it's below the dash on the drivers side In the 2 door it's in the end of the dash on the drivers side ( the removable plastic fuse panel cover can be seen with the drivers door open )
The 1998 Honda Civic drivers side door panel is held on by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
That would be the plastic interior trim panel , by the drivers left foot , just in front of the drivers door