0
The engines on Aerostar vans come out from the bottom. You need a hoist or a winch capable of lifting the front end high enough for the engine to clear. Actually, I've done about 3 of these little gems so far. The easiest way to do it, and if you had the shop manual it would tell you this, is to pull the front end out...Headlights, rad support etc...Pull the engine through the front using a cherry picker type engine hoist. Believe me, you don't want to drop the front end as previously described. I did this in my first overhaul and it took over 3 days just to get the whole thing apart, letalone dropped.lol...
What else can I help you with?
How do you change the license plate bulb on a 1993 Ford Aerostar?
There are two screws holding the lens in place, remove both screws, pull the bulb assembly out, lift the lens off of bulb, pull the bulb straight out to replace it.
Can a minivan pull a trailer?
yes, but it also depends with torque and so on.
Do you have to pull the motor on a 1993 Honda prelude to replace the clutch and fly wheel?
No drop it from under the car.
Where is the gas tank release switch for a 1993 aerostar?
The release switch is on the drivers side on the inside frame near the bottom close to where your seat belt pulls out from. Small arm pull up on it!
What can cause a aerostar transmission not to pull?
The Bands in the transmission are slipping/ the tranny is bad.
Do you have to pull motor of 350 Chevy to change rear freeze plugs?
Pull the motor or pull the transmission, one of them has to come out.
Why 1993 ford aerostar transmission will not pull when i put it drive?
check your fuse, i had the same problem, put in new transmission, did the same thing, replaced 15 amp fuse to speedometer, worked fine. what an ordeal for just a fuse. will cason
How do you replace the blower motor on a 93 Chevy truck?
First, take a socket wrench to remove the cover of the blower motor of a 1993 Chevy truck. Then pull the motor blower out and install a new one in its place. Lastly, screw the bolts of the blower motor cover back in.
If you replaced your 93 Eldorado pull down motor and the trunk still doesn't pull down what else could it be?
The pull down motor switch could be defective. Check for power to the motor
How do you pull 2.2 motor out?
pull all the motor mounts off and disconnect all the pipes and tubes and wires
How do you change the alternator in a 1993 Pontiac grand am 3.3liter?
you should have an motor mount on the passenger side of your car you need to jack the motor up on the oil pan and pull that mount of there should be six bolts to on the top and 4 on the connector plate that connects your motor to the car pull those and that pieces should fall down the you will need to take the belt of the alternator and the remove the bols in the alternator
How do you remove the motor mount?
pull it out
