To install a harmonic balancer on a Buick Riviera, first ensure the engine is at TDC (Top Dead Center) on the compression stroke for the first cylinder. Align the keyway on the balancer with the key in the crankshaft, then slide the balancer onto the crankshaft. Use a harmonic balancer installation tool to press it on evenly and avoid damaging the crankshaft. Finally, torque the retaining bolt to the manufacturer's specified settings.
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
Just put the cam bolt back in and tighten it down, it will go back in easy
behind the harmonic balancer (crank pulley). you need a special puller, and 1/2 drive impact wrench to change it.
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
it is behind the harmonic balancer.
Behind the harmonic balancer.
take off your harmonic balancer the answer is behind
About 200 foot pounds.
yes
sounds like you broke the crank sensor that is mounted right behind the balancer.
It's just behind the harmonic balancer.
its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it