you get a spark plug socket or one of similar size to fit the spark plugs, then you just put it in the correct location and screw it in snuggly(not too tight cause you will break the ceramic casing), then connect all the spark plug wires
You take off the cap. Then pull out the spark plug. Put a new spark plug in. Then put the cap back on. Voila your done. Easy as pie!
hoe do you put then spark plug cable in the right order on a impala
Most snow blowers have the spark plug on top of the motor :to change a spark plug you get a spark plug wrench (take wire cap off the plug) put wrench on spark plug then turn counter clock wise to take it out. To put a new one back in reverse the proses
The silicon stuff is to help keep the spark plug boots from sticking to the spark plug, so put it in the spark plug boot.
take the spark wire off, remove spark plug, put wire back on plug, put steel part of plug against the medal part of engine (with a insulated pare of pliers) then crank the motor over watch the electrode on end of plug if you see spark you have it if you don't ....
the plug that was put in it from the factory.
Sparks plugs are replaced by disconnecting the battery, removing the spark plug cable and boot, and by removing the old spark plug. Next put in the new spark plug, attach the boot and cable and reconnect the battery.
Very simple to do. Purchase 4 new platinum spark plugs for the vehicle. You will need a spark plug socket (it has rubber on it to grip the spark plug you are taking out) and an extension of at least 8 inches. When you open the hood you will see the 4 spark plug leads on top of the engine. Unplug the leads ....put the spark plug socket down each hole and unscrew the spark plugs. The new spark plugs will likely be already gapped to the .043 inches needed. Screw the sparks plug in (I made sure I did not put the spark plug socket on the spark plug too tightly or you could leave the spark plug in the socket hole. A 15 minute job at the most
no
You pull the ruber boot off the top of the spark plug , take the plug out, put boot back on the plug, touch steel part of the plug to steel on motor,pull motor over while watching the gap on the plug if you see spark it should be ok if no spark do the same with a spark plug you know is good to make sure it is the plug. Hope this helps
how to put plug wires on a 1996 Saturn sl
The spark plug wires on your 1994 Chevrolet Caprice are quite easy to change. The spark plug wires simply lift off on each end. Put the new spark plug wires on and push until you feel a click.