5th gear manual overdrive transmition. i want to replace clutch. recently replaced but brakes were locking and caused clutch to burn out.
Can you put a 350 gm motor in 97 ford f150
Yes you can but you might to have to cut the driveshaft or get a shorter one just did it this week.
mine does the same thing usually you can snatch on it and get it out some times it binds up and i put it in third and pop the clutch and it un jams it
Put DOT3 brake fluid in the clutch pump located behind the brake fluid resevoir. Then pump the clutch and that should fix the problem
The water pump on a 1989 Ford F150 5.0 liter is changed by removing the engine accessories, disconnecting the radiator hoses, and removing the retaining bolts. The pump is then pulled from the block, a new gasket put in place, and the new pump installed.
sounds like you have a warped fly wheel, did you have it turned down to specs before put in new clutch,or it could be a faulty pressure plate did you put in a new one [some people try to save a buck and just replace the clutch disc].
ford 460 big block
The clutch and brake share the same fluid
On a 2006 Ford Escape : The brake fluid reservoir is also the clutch fluid reservoir
you put the brake fluid inside the master cylinder
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger
start it and try to put it in gear without using the clutch if it goes the clutch is shot