In the VW manual it says;
Insert the master key into the Ignition lock and switch on the Ignition (don't start the engine), Lock the vehicle from the outside, manually using the second master key or valet key, Press button A or C on the remote control one time and then wait at least 2 seconds, press either button once again, one time, switch off the ignition and remove the key from the ignition lock. This completes the manual programming. Note; You have only 30 seconds to perform steps 2 thru 4
You need to have the dealer do this one as it takes a special computer.
You can use the two keys to reprogram the car remote of 2000 VW Jetta.
How do u program a keyless remote for a 2000 GMC Yukon
Yes , keyless remote entry
To reprogram a 2000 Jeep Grand Cherokee keyless entry remote, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Within 10 seconds, turn the key to the "Off" position and back to "On" three times, ending in the "On" position. After a chime sounds, press any button on the remote to program it. Repeat this step for additional remotes, then turn the ignition to "Off" to exit programming mode.
check
I have a use remote that I need to program
How do you replace the computer on a 2000 montero sport
Must be programed by a Dealer
Yes.
Try this site www.programyourremote.com
how do i program keyless remote for 2000 Buick LeSabre