answersLogoWhite

0

Press and release the foot peddle that is located on the floor

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How can you manually release the emergency brake on the 1998 Toyota Sienna?

How can you manually release the emergency brake on the 1998 Toyota Sienna?


Where is the emergency brake release at for 1998 eldorado?

This is not a professional answer, but if it's anything like my 2001, the parking brake will release once you put the car into gear.


How do change emergency brake pads on a 1998 Pontiac grand prix gtp?

The emergency brakes are whatever your rear brake pads are.


Why does your 1998 Chevy Malibu sound a warning every 30 seconds while driving?

The emergency brake is partially depressed, even though the brake light is not on. release with handle and pull up on the brake pedal.


How do you adjust the emergency brake on a 1998 jetta glx?

You have to lift plastic cover where the emergency brake set into.There will be two nuts,which you either loosen or tighten.


What are the release dates for Wildlife Emergency - 1998?

Wildlife Emergency - 1998 was released on: USA: 7 July 1998


How do you release the emergency break in a 1998 Cadillac Deville?

It is a vacuum release when the car is shifted into drive or reverse. Also has a manual release lever on the e- brake pedal assy. Good luck


How do you replace a starter on a 1998 olds cutlass?

how do you replace a starter on a 1998 cutlass


What is a 1998 olds cutlass what is its value?

what is a 1998 olds moblie cutlass value


On a 1998 Ford Taurus do the rear brake calipers screw in or push in?

AnswerIf the emergency brake cables attach to the calipers SCREW INIf the emergency brake cables are separate, they PUSH INSee "Related Questions" below for more


Where is the switch that controls the brake light on the dash when the emergency brake is on in a 1998 Chevy Malibu?

I had the emergency brake light (and its annoying buzzer) stuck open (on) The switch is located at the top of the emergency brake release pedal in the car. To try to reach it, I took out the cars computer and some wiring, still could not reach it. So I took a long narrow bladed knife and by reaching past the e-brake pedal while applied (down) I was able to cut the wire to the switch. No more annoying buzzer, but now I have to fully apply the brake so I remember to release it when I leave.


There is fluid leaking out of the front wheel area on your 1998 Oldsmobile cutlass?

Most likely brake fluid. Check the master cylinder level.