0
there is always a pressure release valve to remove air for fuel,location is usually on the right top of the motor where the fuel lines come in from the tank. the valve looks like the valve from your tire. just use a nail or something similar to press the valve and air will release then fuel will flow. and don't forget it has a cap.
Answerpressure is usually released by just opening gas cap.
What else can I help you with?
How do you release pressure in the fuel lines on a 2003 Chevy Suburban?
Take off the gas cap.
Why would a 1999 Chevy blazer leak oil only when running?
It is probably the oil cooler lines.
Where is the vacuum canister on a 2001 s10 Chevy blazer?
should be unless it was removed and lines plugged off (not a good idea)
If Oil is leaking from the oil lines coming from the oil filter housing of a 1992 s10 Chevy blazer what is that oil line called and is it one piece?
the lines are call oil cooler lines
Replacing rear brake lines 1999 Chevy blazer ls 4x4?
The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.
Where is the transfer case vacuum switch in a 95 Chevy Blazer S10 V6?
on the top of the transmission its on the transfer case with 3 vacuum lines coming out of it.
Why does a 76 Chevy blazer 4x2 backfire when you give it gas?
It's lean. Best to check the carb and all vacuum lines for leaks and blockage.
How do you change the engine oil cooler lines on a 98 Chevy blazer?
Find the part that needs to be replaced and do what u need to do to get it off if then put the new part on :)
How do I get my 1994 Chevy blazer's 4whl dr button to function?
If the button is not working, might be a vacuum line problem. Vacuum lines engage the 4x4, might need to check the lines to the 4x4 transfer case.
Which port on AC compressor is low pressure 1999 Chevy blazer?
They may be marked "S" and "D" for suction (low side) and discharge (high side). A simpler way would be to look at the lines going into and out of the AC.... the smaller line will be the high pressure line, while the larger line will be the low pressure line. The low pressure line will connect at the compressor inlet, and the high pressure line will connect at the compressor outlet.
Where can you get gas lines for a 1988 s 10 Chevy blazer?
at a salvage yard & some auto parts stores ----- if you omly have a hole you can get a splice kit at auto zone
What do you do if a 1998 Chevy Blazer will turn over but will not start?
fuel problem. make sure you have gas of course, check out your fuel pump, injectors, fuel lines etc.
