To remove the engine from a 2003 Pontiac Vibe, start by disconnecting the battery and draining the engine coolant. Next, remove components such as the air intake, exhaust manifold, and any connecting wiring and hoses. Support the engine with an engine hoist, then unbolt the engine from the transmission and engine mounts. Carefully lift the engine out of the engine bay, ensuring that all connections are fully detached.
The one location to where the fuses for the air conditioner can be on a 2003 Pontiac Vibe. The fuses for the air conditioner will be in the fuse panel located in the engine compartment.
To replace the starter on a 2003 Pontiac Vibe, first disconnect the negative battery terminal to ensure safety. Then, remove any necessary components for access, such as the engine cover or air intake. Unbolt the starter from the engine, disconnect the wiring harness, and remove the starter. Install the new starter by reversing the process, ensuring all connections are secure before reconnecting the battery.
Counter clock wise to loosen.
I understand that the gasoline filter on a 2003 Pontiac Vibe is in the fuel tank, and seldom needs replacement
1.8L
It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.
No such animal . . . Vibe was released in 2003
To remove the rear wiper motor from a 2003 Pontiac Vibe, first, disconnect the negative battery cable for safety. Then, remove the interior trim panel from the rear hatch to access the motor. Disconnect the electrical connector and remove the mounting bolts securing the motor. Once the bolts are removed, you can take out the wiper motor from its housing.
The engine in the Pontiac Vibe is a l.8 litre engine . It is the same engine you will find in the Toyota Corolla. Since the Vibe is very similar to the Toyota Matrix, I assume that the engines are similar as well.
The 1.8 liter four cylinder in a 2003 Pontiac Vibe has a timing CHAIN
A 2003 Pontiac Vibe typically requires about 4.5 quarts of engine oil when performing an oil change with a filter replacement. It's always a good idea to consult the owner’s manual for the specific oil capacity and recommendations for your vehicle.
First you remove the plastic engine cover on top of the valve cover. Then you remove the wires from each of the three coils, then you remove the bolt holding each coil and remove coil. Down in that hole is the spark plug, remove with socket and replace.