these are easy enough to remove . They are fixed with torx bollts size T50 making sure to have long ratchet , Start off with sharp turn to loosen
An individual who is looking to purchase a Ford Transit Minibus can find one from their local authorized Ford dealer in the United Kingdom or other European dealerships. The automobile does not seem to be sold in the United States.
haynes manual or a Ford workshop manual
There is a British website that specialises in Ford Transit parts, called 'Transitparts'. These should have the seats. Also 'Bestpartstore' has a section dedicated to Ford Transit parts.
The 2013 Ford Transit-Connect has 129.6 cu.ft. of cargo capacity with all of its seats in place.
The 2012 Ford Transit-Connect has 129.6 cu.ft. of cargo capacity with all of its seats in place.
The 2010 Ford Transit-Connect has 135.3 cu.ft. of cargo capacity with all of its seats in place.
The 2015 Ford Transit-VAN has 246.0 cu.ft. of cargo capacity with all of its seats in place.
The 2011 Ford Transit-Connect has 135.3 cu.ft. of cargo capacity with all of its seats in place.
The 2014 Ford Transit-Connect has 105.0 cu.ft. of cargo capacity with all of its seats in place.
In a Ford Transit minibus, the door ajar sensor is typically located within the door latch mechanism or on the door frame itself. It detects whether the door is fully closed or not. If the door is slightly open, the sensor sends a signal to the vehicle's computer, triggering a warning light on the dashboard. For specific locations, it's best to consult the vehicle's manual or a service guide.
Remove the bolt holding it in Place
To remove diesel injectors on a Ford Transit Connect, first, ensure the engine is cool and disconnect the battery. Then, remove the engine cover and any components obstructing access to the injectors, such as the intake manifold or fuel lines. Carefully detach the electrical connectors and fuel lines from each injector, and use a suitable tool to unbolt and extract the injectors from their seats. Be cautious to avoid damaging the injector seats or surrounding components during the process.