answersLogoWhite

0

you have to remove lower plastic cover should be two screws this will give you access to barrel holder place the key in barrel and there is a small pin that you have to press in with a small pointy object I used straightened paper clip when you have pushed in the pin turn key to acc then pulling on the key barrel should remove hope this has been of help

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Remove ignition core from 1995 ford e150 van?

Remove the ignition retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition.


How do you remove a Mercedes E200 ignition switch which does not turn with key?

how to remove ignition barrel merc 1995 200e estate


How do you remove a damaged ignition switch in a 1995 Nissan Quest?

how do i remove the ignition switch in a 1995 Nissan quest


How do you remove and replace the ignition switch on a 1995 Dodge Grand Caravan?

You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you remove ignition from 1995 Toyota Paseo?

You need to specify which parts of the ignition system you intend to remove. You can remove ignition from your vehicle entirely by removing the ignition coil wire from the distributor but I don't think that's the answer your looking for.


How do you change ignition control module 1995 Buick Riviera?

Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.


How do you change the Ignition Control Module in a 1995 Blazer S-10?

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


Cant remove the key from a forward position in a 1995 BMW 318I?

Sounds like the security pin in the barrel has snapped, does it just spin round? or sometimes the steering lock causes it to stick. Do a search on bmwland.co.uk/talker for E36 ignition barrel for more info.


How to change ignition barrel on a 1995 astra estate car?

See answer to same question further up this page.


How do you remove an ignition switch in a 1995 rodeo?

First you will need to remove the steering column cover which will expose the ignition switch. Remove the connector and the three bolts holding it on. Pull the switch out and replace.


How do you remove the ignition tumbler in a 1995 mercury tracer?

3 screws facing the engine


How do you remove a rear bumper bar from a 1995 ef Ford Falcon?

you were given brains an hands an eyes, use them