The previous answer was a bit of a dick answer. There are three screws. You have to pull out the front cup holder and remove that screw (might take some work as mine had some glue on the end of it). Then remove the rubber bottom of the back cup holder and remove those two screws (torx screws, so you have to have the right tool). After that, you can pull the console out.
underneath the center console. empty your center console and remove the plastic bin. the amp should be right underneath the bin.
To remove the center console of a 2003 Buick Regal, first, ensure the vehicle is in park and disconnect the negative battery cable for safety. Then, carefully pry off the trim around the console using a trim removal tool, and remove any screws securing the console, usually located in the storage compartment or near the shifter. After that, gently lift the console upwards and away from the dashboard, taking care to disconnect any wiring harnesses for the power outlets or other controls. Finally, remove the console completely from the vehicle.
To remove the center console in a 2003 Pontiac Sunfire, start by disconnecting the negative battery terminal for safety. Then, remove the screws located in the storage compartment and any visible screws along the sides of the console. Carefully pry up the console, disconnect any electrical connectors for the lighter or other components, and lift it out of the vehicle. Ensure you check for any hidden screws or clips before fully removing the console.
I believe the Solara is the same as the Camry. You have to remove part of the center console to access the adjustment.
Best information link regarding center console removal for Yukon/Tahoe below. http://www.salient-designs.com/images/Paper%20Works/SD253B%20Instructions.pdf
To remove the steering wheel from a Renault Clio one must first remove all screws from the back side of the steering column. Once all the screws are removed the steering wheel should be able to be wiggled free.
To remove the floor center console CD player in a 2003 Ford Taurus or Mercury Sable, first, disconnect the negative battery cable to ensure safety. Next, carefully pry off the trim panel surrounding the console using a trim removal tool. Remove any screws securing the CD player, then gently slide the unit out of the console. Finally, disconnect the wiring harness and any additional connectors before fully removing the CD player.
In center console...
In a 2003 Mazda Miata, the airbag control module is typically located beneath the center console, specifically behind the dashboard. To access it, you'll need to remove the center console trim and possibly some surrounding panels. Make sure to disconnect the battery before attempting to work on the airbag system for safety.
on the bottom of the hinge pins there is a nut, you remove that and then lift the doors straight up!!
behind the center console, where you see the heater controls
under the center console way under it